Find

  • All tenders
Netherlands: Tenders/Universiteit Twente/High-resolution, high-speed, low-noise camera

High-resolution, high-speed, low-noise camera

Awarded

The competition has ended and a winner has been selected.

Qualification deadline
Sep 25, 2025Expired
Award
Procedure
Without prior noticeTwo stages
Agreement
Buying goods
Estimated value
€120K

Brief

UT takes the position that the contract can be awarded directly to Acal BFi due to the absence of competition for technical reasons within the meaning of Article 2.32 paragraph 1 sub b bullet 2 Public Procurement Act 2012. According to UT, there is also no reasonable alternative or substitute within the meaning of Article 2.32 paragraph 3 Public Procurement Act 2012 that can meet the reasonable requirements of UT, as stated below: Requirements -The camera should have at least 1.3 megapixel resolution (1280*1024) such that a large number of length-scales can be resolved. -The camera should have at least 31kfps recording rate at full resolution (with global shutter such as to prevent rolling shutter), and should be able to also increase frame-rate for reduced FOV experiments where even faster time-scales needs to be resolved though at the cost of resolution. -The camera should have a temporal dark noise of 7e- or better. -High sensitivity with low noise (ISO 40000 or higher and a quantum-efficiency of 57% or better) such that a relatively small amount of light can be used to observe high-speed events (existing infrastructure includes a high-speed laser for illumination). -12 bit recording mode such that the flow and details can be recorded with large dynamic range  (the combination of low temporal noise, high sensitivity ensures that at high speeds clean recordings can be made of tiny (fluorescent) tracer particles with minimal light). -The camera should have a F and C mount such as to be compatible with existing optics. -The camera should have 3/8-16 UNC (tripod thread) and M4, M5, M6, or M8 mounting screws on the body to rigidly install the device in our setups. -The size of the camera should be limited to 300 mm * 200 mm * 200 mm such that is fits in our set-ups. -The camera should be monochrome without any Bayer filter (to minimize light loss). -The camera should be able to operate between 0–30 degrees Celsius (high room temperatures and down to zero for use inside a cold room). -The camera should have a large memory (more than 100GB) such that long recordings can be made (needed to resolve long-time statistics and to capture rare events that are more common in turbulence than one would expect from normally-distributed events). -The camera should have a variety of input and output signals to trigger and operate it with external hardware (lasers, function generators, trigger-boxes etc): TTL, Sync in/out, SW IN. -The camera should use USB-C or ethernet connection to download the images from the software. -The camera should be compatible with the PFV4 software such that it can operate with existing hardware infrastructure and that the cameras can be programmed and operated using the same software, including doing image calibration to reprogram the CMOS chip to remove noise (“black calibration” or “shading calibration”).

Result

TED
  • Acal BFi
    Winner
  • Number of tenders received
    1
  • Contract value
    €120,000

Previous winners

  • Who are you up against?

    The suppliers who have won similar contracts at Universiteit Twente

Will you bid?

The agent sets up the bid and writes the first draft. Free for 14 days.

Award Criteria

  • Description

    Lowest price

    Source

    No source found in the documents. Check the weight against the tender documents.

From the notice

  • UT takes the position that the contract can be awarded directly to Acal BFi due to the absence of competition for technical reasons within the meaning of Article 2.32 paragraph 1 sub b bullet 2 Public Procurement Act 2012. According to UT, there is also no reasonable alternative or substitute within the meaning of Article 2.32 paragraph 3 Public Procurement Act 2012 that can meet the reasonable requirements of UT, as stated below: Requirements -The camera should have at least 1.3 megapixel resolution (1280*1024) such that a large number of length-scales can be resolved. -The camera should have at least 31kfps recording rate at full resolution (with global shutter such as to prevent rolling shutter), and should be able to also increase frame-rate for reduced FOV experiments where even faster time-scales needs to be resolved though at the cost of resolution. -The camera should have a temporal dark noise of 7e- or better. -High sensitivity with low noise (ISO 40000 or higher and a quantum-efficiency of 57% or better) such that a relatively small amount of light can be used to observe high-speed events (existing infrastructure includes a high-speed laser for illumination). -12 bit recording mode such that the flow and details can be recorded with large dynamic range (the combination of low temporal noise, high sensitivity ensures that at high speeds clean recordings can be made of tiny (fluorescent) tracer particles with minimal light). -The camera should have a F and C mount such as to be compatible with existing optics. -The camera should have 3/8-16 UNC (tripod thread) and M4, M5, M6, or M8 mounting screws on the body to rigidly install the device in our setups. -The size of the camera should be limited to 300 mm * 200 mm * 200 mm such that is fits in our set-ups. -The camera should be monochrome without any Bayer filter (to minimize light loss). -The camera should be able to operate between 0–30 degrees Celsius (high room temperatures and down to zero for use inside a cold room). -The camera should have a large memory (more than 100GB) such that long recordings can be made (needed to resolve long-time statistics and to capture rare events that are more common in turbulence than one would expect from normally-distributed events). -The camera should have a variety of input and output signals to trigger and operate it with external hardware (lasers, function generators, trigger-boxes etc): TTL, Sync in/out, SW IN. -The camera should use USB-C or ethernet connection to download the images from the software. -The camera should be compatible with the PFV4 software such that it can operate with existing hardware infrastructure and that the cameras can be programmed and operated using the same software, including doing image calibration to reprogram the CMOS chip to remove noise (“black calibration” or “shading calibration”).

  • Contact

    Camilio Delfgaauwc.delfgaauw@utwente.nl
  • Type
    Result · Prequalification
  • Main code
    Laboratory, optical and precision equipments (excl. glasses)
    38000000

Similar active competitions

  • České vysoké učení technické v Praze

    Laboratorie-, optisk- og presisjonsutstyr

    Vysokorychlostní kamerový systém pro vědecké účely

    České vysoké učení technické v Praze potřebuje dodávku vysokorychlostního kamerového systému pro vědecké účely do Hlavního města Prahy. Maximální celková hodnota zakázky je 782 900 Kč a doba trvání smlouvy je 2 měsíce. Hodnocení nabídek proběhne na základě celkové nabídkové ceny (100 %). Společnost ARKOL s.r.o. má dnes podobnou smlouvu.

    Competition
    Nov 25, 2026(3 days)
    CZK 782,900
  • Radboud Universitair Medisch Centrum/Radboudumc

    Laboratorie- og analyseutstyr

    Confocal Microscope

    Radboud University Medical Center (Radboudumc) seeks a contractor to supply, install, commission, train users on and maintain a confocal microscope system for its RTC Light Microscopy shared research facility. The system must provide rapid, high-resolution 3D imaging, be user-friendly and future-proof, and support current and future research, with reliable operation and long-term lifecycle support. The contract runs for 10 years and has a maximum total value of €320,000. Quality accounts for 100% of the award score; price is weighted at 0%.

    Competition
    Dec 5, 2026(13 days)
    €320,000
  • Puolustusvoimat

    Fotoutstyr og kamerautstyr

    Suurnopeusvideokamera

    Puolustusvoimien logistiikkalaitos hankkii Satakuntaan suurnopeusvideokameran projektiilien lentoradan kuvaamiseen sekä siihen liittyviä optioita, kuten optiosuurnopeusvideokameran. Sopimuskausi on 3 vuotta, ja hankinnan enimmäisarvo on 880 000 euroa. Tarjouksia vertaillaan hinnan (80 %) ja laatukysymyksistä saatavien pisteiden (20 %) perusteella. Citius Imaging Ltd Oy voitti vuonna 2023 samankaltaisen suurnopeusvideokameraa koskevan hankinnan.

    Competition
    Dec 3, 2026(11 days)
    €880,000