Thin section lapping and polishing equipment and thin section/sample saw

A bid is requested for one (1) thin section lapping and polishing equipment and/or for one (1) thin section/sample saw. Thin section lapping and polishing equipment: The thin section lapping and polishing equipment must be capable of producing polished thin sections, thin sections with surface glass, polished sections, and glued sections made from crushed material. GTK usually uses hot plate and oven impregnating with Araldite and Petropoxy adhesives for the production of thin sections. GTK uses a mineral and polarization microscope and a micrometer to inspect the quality and thickness of the grains. GTK produces thin sections from soft rock (shale) to very hard rock types (granite), as well as glued sections from crushed stone. As a general rule, the rock types in Finland are hard. The most produced sections at GTK are as follows: Polished thin section and section with surface glass, size 48 mm x 28 mm, other sizes are also possible Polished section, size varies, normally sample is round, and the size is 25 mm x 30 mm. Glued gravel section, size varies, normally sample is round, and the size is 25 mm x 30 mm. The thickness of the polished thin section must normally be 0.03 mm, uniform in thickness, and the minerals must have the correct optical color for identification. The surface of the polished thin section must be scratch-free. and/or Thin section/sample saw: Thin section/sample saw is used for sawing bulk rock samples for thin section production. The size of rock samples varies from few cm up to 20 cm in thickness. The saw must be capable of cutting samples with a diameter of at least 10 cm and thin sections sized up to 50 mm x 75 mm.Main features of the procedureThe procurement procedure used is an open procedure. This is a procurement exceeding the EU threshold value. The procurement is subject to the Act on Public Procurement and Concession Contracts (1397/2016) and the regulations and decrees issued under it (614/2007). National regulations are consistent with EU-level legislation. No compensation will be paid to tenderers for submitting a tender, participating in the procedure, or for any related actions. The tender documents are available in English. If the tenderer wishes to receive the documents in another language, the translation and any related costs are the responsibility of the tenderer. All the tender documents submitted have to be in English, if the tender documents are submitted in any other language the tender will be rejected. In an open procedure, the contracting authority publishes a contract notice and makes the invitation to tender available, based on which all interested suppliers may submit a tender. GTK aims to provide the procurement decision 19.12.2025.